BBK

After installing this throttle body my little V6 tried to perform a launch manuever into space... Seriously I could not believe the performance difference it brought to my Stang. Acceleration was smoother and also mpg increased. I might add that if you plan to install this baby, please be careful with the throttle sensor. Broke mine - only 3 in the area, cost me another $100. Easy install (about 1 hour), better performance, and mpg... So, I give this product 5 stars - way to go BBK!!

I just added the 80mm throttle body to my 2000 Trans Am WS6 with the LS-1 and I felt the extra HP and the sound it makes is awesome. It is hard not to burnout now and I LOVE IT!!!!

This is a very nice product for a great price, I added this throttle body a bbk intake manifold and a extra 50 shot of nos and gained 4 tens of a second in the quarter. 99 vette

Great product, would recommend to any One.

Easy install. Only took about 30 min in my driveway.
Noticed a difference right away. Works well with the other
performance mods I have made. Good investment for the $.

I would highly recomend this product. I paid for the throttle body on a sunday and it was sitting at my front door three days later! I didnt notice any horsepower increase but it has great throttle response and torque.

I am not a mechanic by any means, my Throtle was getting stuck on so I replaced it with this one. Just 4 bolts and a gasket and two tubes few screws and wham It was on in about 20 min.
It was basicaly an exact replica of what I had on the truck.
I do believe it was a bit pricey so ill give it 4 stars.

This product is amazing. I just put it on my 02 gmc sierra 2500hd and just starting it you could hear and feel a differance. driving with it, amazing. I had to modify my k&n intake rubber boot to clear the fan but it was simple, before the modification there was a 1/8in. gap between fanblade and boot. The instructions are not very good but its easy to figure out. BBk has awesome customer service if you need any extra instructions. definately worth the time and money.

I purchased the BBK twin 65mm Throttle Body and just love it! Installation was fairly easy, as you disconnect negative terminal of battery first. Then disconnect your throttle cable and linkage from Stock Ford Throttle Body,etc... There is only Two things I found out, you have to be aware of, First the plastic Air Intake tube doesnt fit around the BBK Throttle Body, so you have to modify it by cutting a couple slits at the end to fit larger opening. I then tightened up hose clamp and used duct tape to seal & complete modification. Secondly, make sure you put Throttle Position Sensor on correctly, or you will set off your check engine light and your Truck will run very poorly and lean! I learned the hard way! I called BBK and I was recommended to get a new Throttle Position Sensor and had it put on my BBK for me by a licensed shop. Then I mounted everything on myself, and reconnected the negative terminal on my battery. In regards to performance, lets just say, Whether I am driving on the street laying Two long patches of rubber or I am at the Glamis Sand Dunes, my truck eats up the diesels for lunch! I stongly recommend the BBK Throttle Body to anyone who wants to bolt-on noticeable increased horsepower!!!!!!

THIS WAS A LOT OF HELP YOU FEEL THE POWER.EZ TO PUT ON MY 16 YEAR OLD DID IT ALL MOST BY HIM SELF!!!