Downey

I PUT THIS HEADERS ON MY 2.4LT.TOY TACOMA.IT WORKS GREAT WITH MY GIBSON 2.1\2IN EXHUST. DONT THINK ABOUT IT (JUST DO IT)

The cat is not needed to hook up from the stock or header back. non of the hangers came with or where welded on but other then that it sounds good and has great flow.

very nice quality and appearance,easy installation and better performance too,really does give more power through out the rpm range. it also sounds good,i recomend this to everyone!!!

Great fit and finish...notable performance & fuel economy gains...be sure to follow the installation instructions TO THE LETTER!

The header its self is very nice, but however the EGR flange is incorrect. The flange on your header should not be the style flange that it is, you will have to look at it to understand. The EGR tube coming off the truck is a flat flange that is to mate to another flat flange sealed with a metal gasket. the flange on the header has a lip on it and does not seat properly to my EGR tube.

With a little ingenuity u can tweak it and make it seal, For now I had to double gasket it inorder to stop it from leaking. But I will be welding it instead to make it more secure. I will have to make a custom EGR tube.

So the header is fine if you have a higher skill level in mechanincs to get the two parts to seal and not leak. This is in fact not a exact fit product. But I understand aftermarket and dealt with it.

easy to install, improved power in my little 4 banger,didnt have any problems aligning with my cat. looks good under the hood.

i installed these headers on my 2000 toyota tundra 4.7 with about 215000 miles, and needless to say they didnt fall on. if you have four wheel drive you may want to have lots of patience because it is tight. the passanger side O2 sensor needs to be lengthened, and if you cant stand an exhaust tick, a trip to your local muffler shop is in store. overall after a great product.

This is a great product. It gets rid of all the factory equipment before the throttle body. Looks great and makes good power.

The installation is not as easy as I thought, but it is worth it. The horsepower gain was phenomenal. The only problem I have is a slight exhaust leak which I believe can be fixed with welding of the slip fit joints.

This product was easy and painless to install. I now feel and see a gain in torque, horse power, and fuel economy. Very great product for a 4 cyl Tacoma.