| Write an online review and share your thoughts with other customers about Revtek 2inch Leveling Kit.
Revtek 2
Reviewer: Darrell Ozbun Own this product - Yes
From Tucson, AZ - Vehicle: 1994 DODGE Ram 1500
|
Spacers installed easily to my 2004 Dodge 2500 4wd Diesel. However, I installed 35x13.50x17 (325/70/17) Nitto tires on 17x9 DC-1 wheels with 4.53 backspacing. The tires rub at the trailing edge of the front fenders, when wheels are turned. Also, some rubbing at the front plastic bumper/airdam occured.
I recommend installing longer trailing arms in addition to the leveling kit. Plastic is easier and less painful to trim than the steel fenders.
Smaller tires would also work, 305/70/17 wouldve cleared.
impecable
Reviewer: jody coleman Own this product - Yes
From Tennessee - Vehicle: 2006 DODGE Ram 2500
|
Just put it on my dodge 2500. Fantastic I was able to run 35 inch tires with no rub. Spring compressor not a must. If you plan on big tires and a great look this product is worth the money.
Better stance for my Cummins
Reviewer: From A Customer Own this product - Yes
From North Bend, Or. - Vehicle: 2006 DODGE Ram 2500
|
I've had all three major makes of 4x4's and have always leveled them, this kit was the easiest. The ride is the same, the look even better. You really need a spring compressor, it makes the job much easier. Product is very well made.
Made Huge Improvment
Reviewer: From A Customer Own this product - Yes
From Kinsburg CA - Vehicle: 1994 DODGE Ram 1500
|
Very easy to install and made the truck look 10 times better. The front end was a inch and a half lower and was very noticable in the diffrent wheel well clearances front to rear. Looks perfect now and feels a foot higher. 06' Dodge Power Wagon
2inch kit on 2003 Dodge HD
Reviewer: Forrest Hancock Own this product - Yes
From Tucson, Az - Vehicle: 2003 DODGE Ram 2500
|
Revtek product is great. Had it installed in 1.5 hours. A spring compressor is a must. Truck looks like a truck should once it is on!
Leveling Kit, and Install
Reviewer: Austin Edwards Own this product - No
From Walnut Grove, Ca - Vehicle: 2003 DODGE Ram 2500
|
Have installed a number of 2" kits and the Dodge kit is easy with the lift being installed over the coil. With a spring compressor it can be done in about an hour and a half. Without a spring compressor, it can be done in about 2 and a half hours because you have to drop out more suspension components. Regardless, it is a simple kit to install and customers really like it.
RevTek Lift Lever
Reviewer: Jon Miller Own this product - Yes
From Tacoma, Washington - Vehicle: 1994 DODGE Ram 1500
|
The Rev Tek Lift Lever for Dodge Ram 4x4 '94 and later was an easy to install product with good directions. You will need the spring compressor as the directions suggest. The only way to get by without it is to disconnect the draglink and unbolt the fist set of keeper bolts for the brake lines to get a little more room. The ride or alignment has not changed at all. I would recommend this upgrade for anyone looking to put 35" tires onto there Dodge.
|
Average based on 7 reviews. Write a review.
