Airaid 200-133 QuickFit Intake System With Red SynthaFlow Oiled Filter

I purchased this kit for my 1998 V-6 S-10. Installation was very easy the the unit was ready to go in about a half-hour. Instructions that are included are pretty straight forward and to the point. Ive noticed an increase of about 1-1.5 mpg and also noticed an increase in power. I would recommend this to anyone who is looking for that extra bit of power and a little better fuel efficiency.

This Intake Kit is really cool! I recommend this to anyone that is looking to add that little boost to their truck. You need to get this if your looking for more easy bolt-on power.

This product performs as expected. Nice fit and finish, good attention to detail by Airaid.

Previously had a hand-made intake with a stainless steel mandrel-bent tube, stainless-steel sheet heat shield, and K & N filter. Wasnt rigid enough for mild off-roading and general use.

Airaid seems to perform better since it blocks out the hot air from the engine very well. I am very pleased with this product.

For the price, the product is good. Easy installation, does help with horse power, notice between 2500-3500 rpms. A little increase in mpg. And a drop of approx 100 rpm at idle.

I definitely noticed an improvement in the way my truck gets up and goes. I would recommend this Intake to anyone who is interested in it. No problems ever and I've had it on for 5 months.

I was pretty happy with the performance of this intake. It was a very easy install. Gains were not huge by any means but were noticeable. It got more grunt in the 2500-3500 power band. Throttle response was much better at freeway speeds. It didn't make any noise which can be good or bad. If money is tight but you still want some extra juice when you punch it, this should be a definite consideration.