MSD Replacement 8mm Super Conductor Wire

In a single 12 inch length of MSD Super Conductor Wire there is only 40 - 50 ohms of resistance. That is the lowest resistance of any helically wound wire. The low resistance results in less loss in spark energy so more reaches the spark plug. MSD starts by using copper as the conducter, which is a great carrier of electricity due to it's voltage carrying capabilities. The conductor is wound extremely tight around their ferro-magnetic impregnated center core. So tight in fact, that there is over 40 feet of conductor wrapped into a single foot of plug wire. This winding procedure, combined with their proprietary center core, produces an extremely effective Electro Magnetic Interference (EMI) "choke" with unsurpassed spark output. Finally, MSD uses 2 crimps to make sure that there's no spark arc and you don't end up with the the tip of the boot in the block, separated from wire. This choke, or suppression capability, keeps the EMI inside the wire where it cannot interfere with other electronics on your vehicle. The outer sleeve that surrounds the conductor assembly is just as impressive. A proprietary blend of silicone and synthetic material produce a sleeve that is highly resistant to high heat as well as abrasion and tears. The MSD 8.5mm Super Conductor Plug Wire is available in Universal Kits and Bulk Lengths. All of the MSD spark plug terminals feature "Dual Crimp" terminals. As the name implies, the terminals feature two crimps: One for the sleeve of the wire and another separate crimp to grasp the conductor of the wire. By having separate crimps, the conductor doesn't need to bent 180� and get squeezed between the terminal and sleeve. The individual conductor crimp produces a more secure crimp and there is less chance of spark arcing to the engine block or exhaust through the boot. In fact, MSD feels so strongly about their Dual Crimp terminals that every factory crimped plug wire is guaranteed not to "pull off" for FIVE years.